Garage Door Service & Repair

There is no reset button on any of the modern units (since 1993), so that is probably not the issue.

The reason the garage door got stuck could be one of many things. The manual lock on the door may have been accidentally engaged, or the hardware on the door may need to be adjusted or replaced.

Rollers may be worn out and locked up or you could have a broken spring on the door or bad motor on the opener.

Regardless of the reason, you’re going to have to call and have someone inspect the garage door and make repairs.

Call us at (513) 821-5095 for professional and affordable service if you need help and reside in the Greater Cincinnati – Northern Kentucky area.

We typically see this caused by a bad remote control.  When they get old, the buttons can get stuck, or they can send random signals.

There are some other rare instances where it can be a short in the wiring, or an electronics problem within the unit.

We have even seen it happen when a homeowner keeps a remote in their purse and it gets bumped around, or there is one in a drawer somewhere and the button is pressed.

If your garage door is giving you fits, give us a call at (513) 821-5095 and we’ll take care of it.

The “Learn Code” button is usually on the back or the side of the garage door opener. On most units, there will be a thin wire antenna hanging down on the side that has the learn button.

If after trying to reset the remotes or keypad, you still cannot get them to operate correctly, you’ll need to have the garage door opener looked at.

Give us a call at (513) 821-5095 if you need help with your garage door opener or remotes.

There is usually an adjusting screw on most garage door chain-drive units. You can probably just back it off to get some slack, reset it on the sprockets, and tighten it back up. You will probably then need to adjust the limits.

I’d also recommend you check the sprockets for broken or worn teeth. There has to be a reason it came off in the first place.

If the sprockets are bad, you’ll need to have the opener serviced.

Call us at (513) 821-5095 for a no-hassle appointment.

Most garage doors, when properly adjusted and lubricated, will be reasonably quiet. Some doors and openers are inherently noisy, such as non-insulated steel doors with steel rollers, and screw drive openers…. especially when they have not been lubricated in a while.

To have a quieter garage door you need to have three things:

• A good insulated door;
• Nylon coated ball bearing rollers;
• General maintenance completed on the system once in a while

To have an ultra-quiet system, you need to have the three above, plus;

• A 2-speed belt drive opener

If you need your garage doors serviced in the Greater Cincinnati area, give us a call at (513) 821-5095.

Yes, we carry a wide variety of garage door & opener replacement parts for most common doors and openers. If we don’t have it, and it is available, we can certainly get it for you.

Please take a look at the weekly times our service & repair technicians are available. I’m sure we have something that will fit your busy schedule.

Call us at (513) 821-5095 for more information and to schedule a visit.